MPR121 V12 Proximity Capacitive Touch Sensor I2C Interface Module Water Pump For Waterfall 30ms/115VAC at full load Hold

30ms/115VAC at full load Hold Up Time 55ms/230VAC 10ms/115VAC at full load

A six wire cable from the Power Module is plugged into your Pixhawk/APM power port

Metal and plastic

Knob Diameter 15mm Knob Height 17mm

GRAYSCALE Operating Temperature -20 °C - 85 °C

MPR121 V12 Proximity Capacitive Touch Sensor I2C Interface Module Water Pump For Waterfall 30ms/115VAC at full load HoldThis MPR121 is a capacitive touch sensor controller driven by an I2C interface. The chip can control up to twelve individual electrodes, as well as a simulated thirteenth electrode The MPR121 also features eight LED driving pins, when these pins are not configured as electrodes, they may be used to drive LEDs. There are four jumpers on the bottom of the board, all of which are set (closed) by default. An address jumper ties the ADD pin to the ground,