MOOSE RACING Water Pump Rebuild Kit 821328MSE Taillight and License Plate Holder with Turn Signal 2019-2024 Can-Am Ryker 600 ACE

2019-2024 Can-Am Ryker 600 ACE - - 2019-2024 Can-Am Ryker 900 ACE - -

All Graves Motorsports fender eliminator kits are fabricated from black anodized aluminum for long term reliability and great looks

Merged the 1-7/8" head pipes into a large 2-1/4" collector that steps up to a 2-1/2" perforated core Core wrapped in stainless steel screen then encloded in fiberglass pillow Collector covered by large one-piece heat shield that is held in place with two clamps and stamped Cobra logo 4" muffler body capped with a 4" machined aluminum dual-cut tip that features small alluvial flutes Body arrives pre-set in slight upward position Works wtih stock or extended bags

Works seamlessly with Cobra® detachable back rests Same proprietary release mechanism as the back rests Installed or removed in a matter of seconds Can be used with or without back rests but requires stock or Cobra® hardware kit

2010-2016 Honda VT1300CR Stateline - - 2010-2016 Honda VT1300CS Sabre - - 2010-2016 Honda VT1300CX Fury - -

MOOSE RACING Water Pump Rebuild Kit 821328MSE Taillight and License Plate Holder with Turn Signal 2019-2024 Can-Am Ryker 600 ACEInclude every gasket, O ring, bearing and seal required to rebuild a water pump Typical kit includes the following: bearings where applicable; rubber seals; mechanical water pump seal where applicable; side cover gasket; water pump gasket; snap rings located on water pump shaft and copper drain washers