Sherline Lathe Live Center Part Number 1191 Pipe Bender The ground surfaces have been

The ground surfaces have been protected with packing grease and paper and a part of the grease covered surface has been shown in photographs

With a barrel-shaped red-stained birch handle and a 2

Magnesium Alloy

Cutting edges designed to cleanly cut all types of wire: soft wires and modern materials to a maximum piano wire specification of: 2mm 210 kg/mm²

These diminutive pliers are beautifully made and feature stainless steel construction with serrated flat gripping jaws as well as heavy cutting jaws on the underside of the joint just above the handles

Sherline Lathe Live Center Part Number 1191 Pipe Bender The ground surfaces have beenThe Sherline lathe comes equipped with two dead centers that fit the headstock and tailstock. These centers are used for holding parts that are mounted between centers. This system of mounting work in a lathe has been in use for many years. However, since the tailstock center is held stationary and does not turn with the part, it is a point of friction and requires frequent oiling and attention. Also, because of thermal expansion caused by friction