Laser Engravable Rubber - Super Thin Seals & Embossers The pad is housed in

The pad is housed in an air-tight plastic container with two hinged covers -- one on top and one on the bottom so the pad is reversible

ACE 12 -- 7" x 11" -- Metal Lid

2770 - 16 black

heavy gauge 7 mil thickness

The 12" tubes will fit our Polymer Plus Model 150 unit and the MB-100 unit

Laser Engravable Rubber - Super Thin Seals & Embossers The pad is housed inApproximately . 060 or 1 16 thick (1. 5mm). 8 x 11 sheets. Must be washed with detergent and water after engraving. Confirm that your laser equipment is suitable for engraving stamp dies. Check with your laser equipment manufacturer to determine compatibility of equipment and software. The settings below are a good starting point as you begin test engraving this material. Use your lasers software settings for stamp mode or 3D effects mode. Adjust