Flexible Protoboard - 20cm x 30cm _MAKE_LED_STANDARD You’ll need the Crankshaft Kit

You’ll need the Crankshaft Kit and some other 3D printed parts to fully assemble this little beastie

Conductive fabric with ~10 ohms per foot resistance

4 x AAA alkaline batteries to power the inverter and tape for 10 hours

10 x jumper wires male to male

1 x Mini breadboard

Flexible Protoboard - 20cm x 30cm _MAKE_LED_STANDARD You’ll need the Crankshaft KitMake your next project super flexy with a biiiig prototyping board that can twist and shout err, twist and bend! This passive flexible proto PCB is about large as a piece of paper, but instead of dead trees its made of very thin FR4. We're not bending the truth! This protoboard is only 0. 4mm thick, so its extremely bendable and you can cut it easily with scissors just don't use your nice fabric scissors since the fiberglass will dull them. It has a