LC29H(BS) GPS/RTK HAT for Raspberry Pi _MAKE_COMP_OTHER If you're using this to

If you're using this to test USB C be sure to get a cable with E-Mark power negotiation chips inside so you get the proper current and voltage out - many cheap USB C cables skip this part and won't work well for high-current/voltage charging

the pin order is: GND

and has the gold reset pin in the correct place

You can even include your favourite SparkFun libraries and use them as if you were running the code on a RedBoard

5 inch HDD/SSD with the drive height of 7mm

LC29H(BS) GPS/RTK HAT for Raspberry Pi _MAKE_COMP_OTHER If you're using this toThis GPS RTK HAT can track dual frequency L1+L5 GNSS signals, substantially reducing multipath interference in urban environments and enhancing positioning accuracy. This module is compatible with Raspberry Pi series boards and Jetson Nano through its standard 40 pin GPIO extension header. It supports concurrent reception of multiple GNSS systems, including GPS, BDS, GLONASS, Galileo, and QZSS, which enables it to provide consistent and low power