White Nylon Screw and Stand-off Set – M2.5 Thread _RPI_SD They tend to draw ~25mA

They tend to draw ~25mA or so in practice but for precise numbers you must measure the current in your usage circuit

BLE module G-sensor and LCD

The I2C address bits are selectable using the on-board jumpers

Audio is handled by the Pi's built in audio system

The devices conform to the HomePlug AV specification and deliver a peak data rate of 200Mbps at the physical layer and about 80Mbps at the MAC layer

White Nylon Screw and Stand-off Set – M2.5 Thread _RPI_SD They tend to draw ~25mATotalling 420 pieces, this White Nylon M2. 5 Screw Set is a must have smrgsbord for your workstation. You'll have more than enough screws, nuts, and hex standoffs to construct your maker projects for days on end! M2. 5 screws fit nearly all of the Adafruit breakout development board mounting holes (2. 5mm or 0. 1" drill holes). These screws work handsomely with our Feathers, breakout boards, HATs and more! Since the screw set is nylon, you can file