AudioFrog TP-50V2 - Tweeter Protector for use in Active Systems drop down monitor crossover point: 3500 Hz at

crossover point: 3500 Hz at 18 dB/octave

8 Rubber feet

Alpine Status high-resolution centralized power plant

Hard-wire kit and 12-volt adapter kit included

An LED light on the module indicates on/off status

AudioFrog TP-50V2 - Tweeter Protector for use in Active Systems drop down monitor crossover point: 3500 Hz atDescription The TP 50V2 is intended to protect your tweeters from electronic component failure, DSP software glitches or failures and from erroneous crossover settings. The TP 50V2 will remove low frequency content from the signal and is only active below the crossover you implement in the DSP or the amplifier. The TP 50V2 will not protect against too much power above the crossover caused by bad gain setting procedure, an amplifier thats way too